Viewing The Generic Tunnel Statistics; Viewing A List Of Generic Tunnels; Adding A Generic Tunnel - Siemens RX1500 User Manual

Chapter 5
Setup and Configuration
Section 5.29.7.1

Viewing the Generic Tunnel Statistics

To view the generic tunnel statistics, navigate to tunnel » l2tunneld » status » generic. The Generic L2 Tunnel
Statistics form appears.
1
Figure 768: Generic L2 Tunnel Statistics Form
1. Tunnel Name 2. Interface Name
This table provides the following information:
Parameter
tunnel-name
Section 5.29.7.2

Viewing a List of Generic Tunnels

To view a list of generic tunnels, navigate to tunnel » l2tunneld » generic. If tunnels have been configured, the
Generic L2 Tunnel Protocol table appears.
Figure 769: Generic L2 Tunnel Protocol Table
If no generic tunnels have been configured, add tunnels as needed. For more information, refer to
Section 5.29.7.3, "Adding a Generic
Section 5.29.7.3

Adding a Generic Tunnel

To configure a generic tunnel, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
Navigate to tunnel » l2tunneld » generic and click <Add tunnel>. The Key Settings form appears.
2.
654
2 3 4
3. RX Frames 4. TX Frames
Description
The generic tunnel name.
Tunnel".
5 6 7
5. RX Characters 6. TX Characters 7. Errors
Viewing the Generic Tunnel Statistics
RUGGEDCOM ROX II
User Guide