Siemens RX1500 User Manual page 275

RUGGEDCOM ROX II
User Guide
Figure 253: SFTP Sessions
1. Enabled Check Box
3. Configure the following parameter(s):
Parameter
enabled
Listen IP
Listen Port
Extra IP:Ports
Enabling and Configuring SFTP Sessions
1
2
3
4
5
2. Listen IP Box 3. Listen Port Box
Description
Default: false
Enables/Disables the SFTP user interface.
Synopsis: The ip-address type represents an IP address and is IP version neutral.
The format of the textual representations implies the IP version.
Default: 0.0.0.0
The IP Address the SFTP will listen on for SFTP requests.
Synopsis: The port-number type represents a 16-bit port number of an Internet
transport layer protocol such as UDP, TCP, DCCP, or SCTP. Port numbers are assigned
by IANA. A current list of all assignments is available from <http://www.iana.org/>. Note
that the port number value zero is reserved by IANA. In situations where the value
zero does not make sense, it can be excluded by subtyping the port-number type. In
the value set and its semantics, this type is equivalent to the InetPortNumber textual
convention of the SMIv2.
Default: 2222
The port the SFTP will listen on for SFTP requests.
Synopsis: "extra-ip-ports" occurs in an unbounded array
The SFTP will also listen on these IP Addresses. For port values, add ':#' to set non-
default port value. (ie. xxx.xxx.xxx.xxx:19343 [::] [::]:16000). If using the default address,
do not specify another listen address with the same port.
4. Extra IP Ports Box 5. Maximum Number of SFTP Sessions Box
Chapter 5
Setup and Configuration
243