Setting The Maintenance Password/Passphrase - Siemens RX1500 User Manual

Chapter 4
System Administration
Section 4.10.4

Setting the Maintenance Password/Passphrase

The maintenance password/passphrase grants access to the maintenance mode, which is only accessible
through the Command Line Interface (CLI). For more information about this mode, refer to the ROX II v2.6 CLI
User Guide.
CAUTION!
Configuration hazard – risk of data corruption. Maintenance mode is provided for troubleshooting
purposes and should only be used by Siemens Canada Ltd. technicians. As such, this mode is not fully
documented. Misuse of this maintenance mode commands can corrupt the operational state of the
device and render it inaccessible.
To set the maintenance password, do the following:
NOTE
A passphrase must consist of four separate words and each word must be 4 to 20 characters long.
1. Navigate to admin » authentication » set-maint-password. The Set Maint Password and Trigger Action
forms appear.
Figure 245: Set Maint Password Form
1. New Password Box
230
1
2
3
2. New Password Repeat Box 3. Old Password Box
Setting the Maintenance Password/Passphrase
RUGGEDCOM ROX II
User Guide