Viewing The Status Of Ldp Binding - Siemens RX1500 User Manual

RUGGEDCOM ROX II
User Guide
• Section 5.39.7.1, "Viewing the Status of LDP Binding"
• Section 5.39.7.2, "Viewing the Status of the LDP Discovery Interfaces"
• Section 5.39.7.3, "Viewing the Status of the LDP Neighbor Local Node Information"
• Section 5.39.7.4, "Viewing the Status of the LDP Neighbor Connection Information"
• Section 5.39.7.5, "Viewing the Status of the LDP Neighbor Discovery Information"
• Section 5.39.7.6, "Configuring LDP"
• Section 5.39.7.7, "Configuring Neighbor Discovery"
• Section 5.39.7.8, "Viewing a List of LDP Interfaces"
• Section 5.39.7.9, "Enabling/Disabling an LDP Interface"
Section 5.39.7.1

Viewing the Status of LDP Binding

To view the status of the LDP binding on the device, navigate to mpls » ldp » status » binding. If LDP interfaces
have been configured, the LDP Binding Status Information table appears.
Figure 939: LDP Binding Status Information Table
This table provides the following information:
Parameter
Prefix
Local Label
Next Hop
Remote Label
In Use
Viewing the Status of LDP Binding
Description
The LDP transport prefix.
The incoming (local) label.
The destination next hop router.
The LDP remote label.
The LDP in-use flag.
Chapter 5
Setup and Configuration
813