Viewing A List Of Static Cross-Connects; Adding A Static Cross-Connect - Siemens RX1500 User Manual

Chapter 5
Setup and Configuration
Parameter
Local Label
Outgoing Label
Outgoing Interface
Next Hop
If no static cross-connects have been configured, add cross-connects as needed. For more information about
adding static cross-connects, refer to
Section 5.39.6.2

Viewing a List of Static Cross-Connects

To view a list of configured static cross-connects, navigate to mpls » static-mpls » crossconnect. If cross-
connect labels have been configured, the Static MPLS Cross-Connects table appears.
Figure 935: Static MPLS Cross-Connects Table
If no static cross-connects have been configured, add cross-connects as needed. For more information about
adding static cross-connects, refer to
Section 5.39.6.3

Adding a Static Cross-Connect

To add a static cross-connect, do the following:
Change the mode to Edit Private or Edit Exclusive.
1.
2. Navigate to mpls » static-mpls » crossconnect and click <Add dest-address>. The Key Settings form
appears.
810
Description
The incoming (local) label.
The outgoing (remote) label.
The outgoing interface.
The destination next hop router.
Section 5.39.6.3, "Adding a Static
Section 5.39.6.3, "Adding a Static
Cross-Connect".
Cross-Connect".
Viewing a List of Static Cross-Connects
RUGGEDCOM ROX II
User Guide