Siemens RX1500 User Manual page 624

Chapter 5
Setup and Configuration
• a backup VRRP router gains higher priority and transitions to the Master state
• VRRP is initiated and this router has higher priority than that of any VRRP router on the network
NOTE
The VRRP Instance Form displays some fields differently depending on whether version 2 or
version 3 is chosen in the version field.
• Choosing VRRP version 2 displays the Advertisement Interval field.
• Choosing VRRP version 3 displays the Advertisement Interval Millisecond field.
Parameter
VRRP Version
Interface
Virtual Router ID
Priority
Advertisement Interval
Advertisement Interval MilliSecond
Gratuitous ARP Delay
No Preempt
Preempt Delay
Fault to Master Delay
Use Virtual MAC
VRRP Group
7. Add one or more VRRP monitors. For more information, refer to
8. Add one or more track scripts. For more information, refer to
9. Add one or more virtual IP addresses. For more information, refer to
Address".
10. Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
11. Click Exit Transaction or continue making changes.
592
Description
Default: 2
Configure VRRP version for this instance.
The interface that will host the VRIP when the router becomes the VRRP Master.
The Virtual Router ID. All routers supplying the same VRIP should have the same VRID.
The priority for the VRRP instance. When electing the master, the highest priority wins.
The configurable range is 1 to 255. A value of zero (0) is invalid.
Default: 1
VRRP2 advertisement interval, in seconds.
Default: 1000
Prerequisite: Value of advert-interval-millisecond must be multiple of 10.
VRRP3 advertisement interval in millisecond, must be multiple of 10.
Default: 5
Gratuitous ARP delay, in seconds. Sets the delay after the router changes state state
before a second set of gratuitous ARPs are sent.
When enabled, a lower priority router maintains its role as master even if this router has
a higher priority.
Default: 0
The time, in seconds, after startup until preemption.
Default: 0
The delay, in seconds, before a transition from the fault state to the master state occurs,
thereby preempting the current master.
When enabled, the router uses a virtual MAC address for the VRIP interface.
Binds this VRRP instance to a VRRP group.
Section 5.26.8.2, "Adding a Track
Section 5.26.7.2, "Adding a VRRP
Section 5.26.9.2, "Adding a Virtual IP
Adding a VRRP Instance
RUGGEDCOM ROX II
User Guide
Monitor".
Script".