Ethernet/Ip Slave Board Installation - Epson RC620 Manual

2.3.4 EtherNet/IP Slave Board Installation

Appearance
The Fieldbus slave board is configured as follows at shipment.
Board Appearance
CN3
DSW2
DSW1
JMP1
Specifications
Name
Code
Supported Connection
Baud Rates
Transfer Distance
Cable
Mode
Interface
Max. Input data size
Max. Output data size
RC620 Option Fieldbus I/O Rev.8
Status Display LED
Configure Switch
EtherNet/IP Connector
Configuration
CN3
All Open
Item
EtherNet/IP slave board
R12B040719
I/O messaging connection (Cyclic),
Explicit messaging connection
EtherNet/IP communication protocol
10 M, 100 M (bps)
Standard Ethernet protocol
Standard Ethernet protocol
Slave
1 EtherNet/IP port
256 bits (32 bytes)
256 bits (32 bytes)
MS LED : Module status display
NS LED : Network status display
LNK LED : Communication packet reception
or transmission status display
ACT LED : Link status display
The LED shows the board status.
For details, refer to the section LED Description.
DSW2
SW8
SW7
SW4
SW6
SW3
SW5
SW2
SW4
SW1
SW3
SW2
SW1
All ON Fixed as above
Specification
2. Installation
DSW1 JMP1
IRQ15
IRQ11
IRQ10
IRQ7
IRQ5
1 2
All Open
JP5
JP4
JP3
JP2
JP1
107