Epson RC620 Manual page 46

2. Installation
18. Select [File]-[Download in Flash] from the applicomIOR console menu. Register the
 NOTE
19. After few seconds, the display of "Configured boards state" on the status bar turns to
20. Close the applicomIO Console application.
21. Refer to the section EPSON RC+6.0 configuration and continue the step.
36
configuration to the Fieldbus master board.
Make sure that the flash memory of Fieldbus master board stores the
configuration; otherwise the Fieldbus master board cannot correctly function.
Also, you cannot control it from EPSON RC+6.0.
If you changed the configuration, select [File]-[Download in Flash] from the
applicomIOR console menu and register the configuration to the Fieldbus master
board.
green.
Now, the Fieldbus master board is ready to operate in the master mode.
RC620 Option Fieldbus I/O Rev.8