Epson RC620 Manual page 113

 NOTE
RC620 Option Fieldbus I/O Rev.8
24. Click <OK> and complete the registration.
25. Select [File]-[Download in Flash] from the applicomIOR console menu. Register
the configuration to the Fieldbus master board.
Make sure that the flash memory of Fieldbus master board stores the
configuration; otherwise, the Fieldbus master board cannot function correctly.
Also, you cannot control it from EPSON RC+6.0.
If you changed the configuration, select [File]-[Download in Flash] from the
applicomIOR console menu and register the configuration to the Fieldbus master
board.
26. After a few seconds, the display of "Configured boards state" on the status bar
turns to green.
Now, the Fieldbus master board is ready to operate in the master mode.
27. Close the applicomIO console application.
28. Refer to the section EPSON RC+6.0 configuration and continue the step.
2. Installation
103