Remote Control Input And Output Setting - Epson RC620 Manual

3.5 Remote Control Input and Output Setting

Remote control inputs and outputs are not allocated to fieldbus I/O by default.
To allot remote control inputs and outputs to fieldbus I/O, follow the steps below.
(1) Select EPSON RC+6.0 menu-[Setup]-[System Configuration] and display the [System
(2) Click <Defaults> to display the [Default Remote Type] dialog box.
(3) Select [Fieldbus Master I/O] or [Fieldbus Slave I/O] and click <OK>.
(4) Fieldbus I/O will be allotted default remote control input and output setting. Select bit
(5) Click <Apply> to save the settings. Then, click <Close>.
To enable the remote control, refer to EPSON RC+ 6.0 User's Guide 11. Remote Control.
RC620 Option Fieldbus I/O Rev.8
Configuration] dialog box. Select-[Controller]-[Remote Control]-[Inputs] or [Outputs].
numbers by clicking the input or output numbers corresponding to the signals to be
used for remote control.
3. Operation
133