Replacement Of Brake Resistor Bleeder For Pmc Small - ABB IRC5 Product Manual

4 Repair

4.19 Replacement of brake resistor bleeder for PMC small

4.19 Replacement of brake resistor bleeder for PMC small
Location
The illustration below shows the location of the brake resistor bleeder in the PMC
small. Note! The brake resistor bleeder is placed on the back of the drive module.
xx0600003251
A
Required equipment
Equipment
Brake resistor bleeder
Standard toolkit
Other tools and procedures may be required.
See references to these procedures in the
step-by-step instructions below.
Circuit diagram
Removal
The following procedure details how to remove the brake resistor bleeder.
1
Continues on next page
202
Brake resistor bleeder
Action
DANGER
Before commencing any work inside the
cabinet, please observe the safety inform-
ation in section Make sure that the main
power has been switched off on page
© Copyright 2007-2018 ABB. All rights reserved.
Note
See Drive module parts for PMC large on
page 233.
The contents are defined in section Stand-
ard toolkit
These procedures include references to the
tools required.
See Circuit diagrams on page
Note/illustration
25.
Product manual - IRC5 Panel Mounted Controller
3HAC047137-001 Revision: J
249.