Replacement Of Brake Resistor Bleeder - ABB IRC5 Product Manual

4 Repair activities, controller IRC5

4.18. Replacement of brake resistor bleeder

4.18. Replacement of brake resistor bleeder
Location
The illustration below shows the location of the brake resistor bleeder in the IRC5 Panel
Mounted Controller. Note! The brake resistor bleeder is placed on the backside of the Drive
Module.
xx0600003251
A
Required equipment
Equipment
Brake resistor bleeder
Standard toolkit
Other tools and procedures may be required.
See references to these procedures in the
step-by-step instructions below.
Circuit diagram
Removal
The following procedure details how to remove the brake resistor bleeder.
170
Brake resistor bleeder
Action
1.
DANGER!
Before any work inside the cabinet, please
observe the safety information in section
DANGER - Make sure that the main power
has been switched off! on page
Note
See Drive Module parts on page
The contents are defined in section
Standard toolkit
These procedures include references to the
tools required.
See Circuit Diagram on page
Note/Illustration
26.
3HAC027707-001 Revision: D
184.
195.
Continues on next page