ABB IRC5 Product Manual page 56

2 Installation and Commissioning, IRC5
2.5.2. Connecting power supply to the IRC5 Panel Mounted Controller
Continued
Required equipment
Equipment
Incoming power cable
Line filter
Standard toolkit
Circuit diagram
Connecting incoming power 3x262V 10A to Drive Module
The following procedure details how to connect power supply to the Drive Module.
54
Action
1. Place the Line filter near to the Drive
Module and it must be on the same
ground.
2. Connect 3x262V 10A to the Line filter
(LINE).
3. Route, strap and connect the Line
filter (LOAD) to the contactor K42: 1,
3, 5.
Recommended tightening torque on
the contactor K42 screw terminal is
1.00 Nm
Max. tightening torque on the
contactor K42 screw terminal is 1.20
Nm.
4. Connect incoming earth cable to PE.
Note
See Miscellaneous parts on page
The contents are defined in section
Standard Toolkit
See Circuit Diagram on page
Note/Illustration
xx0600003315
xx0600003316
• A: incoming power 3x262V 10A wires
• B: incoming earth cable
Continues on next page
3HAC027707-001 Revision: D
186.
195.