Section 3 How To Enter Programming Mode; Section 4 How To Exit Programming Mode - NEC SL1000 Programming Manual

SL1000
second row of the display "KY01 =
*
01. The third row allows you to move the cursor to the left or right, depending on which arrow is
pressed. To learn how to enter the programming mode, refer to
this page below.
S 3 HOW TO ENTER PROGRAMMING MODE
ECTION
To enter programming mode:
1 Go to any working display telephone.
In a newly installed system, use extension (port 1).
2 Do not lift the handset.
3 Press Speaker.
* *
4 # # .
5 Dial the system password + Hold. Refer to the following table for the default system passwords. To
change the passwords, use
Password User Name
********
nec-i
12345678 tech
0000 admin1
9999 admin2
S 4 HOW TO EXIT PROGRAMMING MODE
ECTION
To-exit the programming mode:
When you are done programming, you must be out of a program option to exit (pressing the
DND/CONF key will exit the program option).
1 Press DND/CONF key to exit the program options, if needed.
1-2
*
01" indicates that Key 01 is being programmed with the entry of
90-02 : Programming Password Setup
Level
1(MF) Manufacture Level (MF)
80-02, 81-04, 81-05, 82-02, 82-05,
2 (IN) Installation (IN):
All programs in this section not listed for MF, SA, & SB
3 (SA) System Administrator - Level 1 (SA):
10-01, 10-02, 10-12, 10-13, 10-14, 10-15, 10-16, 10-17, 10-18, 10-23,
10-24, 10-25, 10-28, 10-29, 10-45, 12-02, 12-03, 12-04, 12-08, 15-01,
15-07, 15-09, 15-10, 15-11, 20-16, 20-34, 21-07, 21-14, 22-04, 22-11,
22-17, 25-08, 30-03, 30-04, 32-02, 45-02, 84-22, 90-03, 90-04, 90-06,
90-07, 90-19, 90-57, 90-58, 90-59, 90-65
4 (SB) System Administrator - Level 2 (SB):
13-04, 13-05, 13-06, 13-11, 21-20
How to Enter Programming Mode
on page 2-489.
Programs at this Level
Issue 0.1
on
Introduction