NEC SL1000 Programming Manual page 217

Issue 0.1
Item No. Item
10 Dial Digits for Toll Restriction
Path
If this option is programmed with
an entry other than 0, a call does
not have a talk path unless the
user dials at least the number of
digits entered in this option when
placing an outgoing call.
This means that an entry of 4 or
higher in this program causes a
problem when dialing 911(USA
only). Since it is only a 3-digit
number, the call does not have a
talk path, preventing the emer-
gency dispatcher from hearing the
caller. This option should be kept
at its default setting of 0 to prevent
any problems with dialing 911
(USA only).
11 Inter-Digit Time for Toll Restric-
tion Path Control
12 Dial E911 Routing Without Trunk
Access
If enabled (1), an extension user
can dial 911 (USA only) without
first dialing a trunk access code or
pressing a line key. If disabled (0),
an extension user must dial a trunk
access code (e.g., 9) or press a
line key before dialing 911 (USA
only).
13 Alarm Ring Timer (E911)
Use this option to set the duration
of the E911 Alarm Ring Time. If set
for 0, the E911 Alarm does not
ring.
14 Forced Account Code Inter-digit
Timer
The system waits this time for a
user to enter a Forced Account
code.
15 Outgoing Disable on Incoming
Line (Toll Restriction)
Enable or disable the Outgoing
Disable on Incoming Line feature.
16 Supervise Dial Detection Timer
With the Outgoing Disable on
Incoming Line feature, if dial tone
is not detected after the extension
answers an incoming line, the
system determines the call is
unable to complete and releases
the DTMF receiver.
17 Restriction Digit in Outgoing
Disable on Incoming Line
With the Outgoing Disable on
Incoming Line feature, determine
the number of digits to be dialed
before the call should be
disconnected.
18 Reset Dial After Failure of Trunk
Access
Enable (1) or Disable (0) the ability
to continue to dial codes or exten-
sions after receiving Trunk Busy.
This needs to be set to Enabled (1)
for the Forced Trunk Disconnect
feature to work.
Programming Manual
Input Data
0~24
0~60 (sec)
0 = Trunk Access Code
Required
1 = Trunk Access Code
Not Required
0, 1~64800 (sec)
(0 = Off)
0~64800 (sec)
0 = Disable (Off)
1 = Enable (On)
0~64800 (sec)
Digits 1~9
0 = Disable (Off)
1 = Enable (On)
SL1000
Default Related Program
0
10
1
0 11-12-56
20-08-16
3
0 15-01-05
21-01-16
21-01-17
80-03-01
20 15-01-05
21-01-16
21-01-17
80-03-01
4 15-01-05
21-01-15
21-01-16
80-03-01
0
Program
21
2-197