Selectable Display Messages - NEC SL1000 Programming Manual

Issue 0.1
Level
SA
Description
Use Program 20-16 : Selectable Display Messages to enter the Selectable Display Messages.
There are 20 alphanumeric messages, with up to 24 characters. Use the following chart when
programming messages.
Use this keypad digit . . .
1
2
3
4
5
6
7
8
9
0
*
#
Clear/Back
Flash
When using DTP or DTU style telephones on the SL1000 system, not all the same characters are
available.
Input Data
Selectable Display Message Number
Item No.
01
Default
Number
1
2
3
4
5
Programming Manual
Program 20 : System Option Setup

20-16 : Selectable Display Messages

Enter characters:
Enter characters: A-C, a-c, 2.
Enter characters: D-F, d-f, 3.
Enter characters: G-I, g-i, 4.
Enter characters: J-L, j-l, 5.
Enter characters: M-O, m-o, 6.
Enter characters: P-S, p-s, 7.
Enter characters: T-V, t-v, 8.
Enter characters: W-Z, w-z, 9.
Enter characters:
Enter characters:
# = Accepts an entry (only required if two letters on the same key are needed - ex:
TOM). Pressing # again = Space. (In system programming mode, use the right
arrow soft key instead to accept and/or add a space.)
Clear the character entry one character at a time.
Clear all the entries from the point of the flashing cursor and to the right.
IN MEETING UNTIL ##:##
MEETING ROOM - ########
COME BACK ##:##
PLEASE CALL ###########
BUSY CALL AFTER ##:##
When you want to . . .
01~20
Input Data
16 characters
Message
SL1000
Program
20
2-163