NEC SL1000 Programming Manual page 28

SL1000
I e t m N . o
13
14
15
Program
16
10
17
18
19
20
21
22
23
For DTI (T1) PKG Setup
I e t m N . o
01
02
03
2-8
I e t m
Loss-Of-Signal Detection Limit
If the transmit/receive voltage is less
than the setting in 10-03-13, the
system considers this as Loss-Of-
Signal and the PRI does not come up.
Note that there are different values
based on the setting in 10-03-12 for
the PRI.
Service Protocol for S-point
Call Busy Mode for S-point
Two B-Channel Transfer for PRI
Service
ISDN Ringback Tone
System can provide ringback tone, by
setting 10-03-17 is set to 1:Enable.
Type of Number
ISDN Protocol definition.
Select the number type for the ISDN
circuit.
Numbering Plan Identification
ISDN Protocol definition.
Select the Numbering Plan used for
the ISDN circuit.
Network Exchange Selection
Select the ISDN protocol for the ISDN
circuit.
Number of Ports
QSIG Operation Mode
Straight/Cross Wiring
Physical Port Number
I e t m
Logical Port Number
The start port number of a T1 line is
displayed, and 24 logic ports are
automatically assigned to a DTI (T1)
line.
T1 Signal Format Selection
Zero Code Suppression
n I p t u D a a t
0 = Level 0 (lowest sensitivity)
1 = Level 1
2 = Level 2
3 = Level 3
4 = Level 4
5 = Level 5
6 = Level 6
7 = Level 7 (highest sensitivity)
0 = Keypad facility
1 = Specified Protocol for Aspire system
0 = Alerting
1 = Disconnect
0 = off
1 = on
0 = Disable
1 = Enable
0 = Unknown
1 = International number
2 = National number
3 = Network Specific number
4 = Subscriber number
5 = Abbreviated number
0 = Unknown
1 = ISDN numbering plan
2 = Data numbering plan
3 = Telex numbering plan
4 = National standard numbering plan
5 = Private numbering plan
0 = Standard (same as NI-2)
1 = reserved
2 = reserved
3 = DMS (A211)
4 = 5ESS
5 = DMS (A233)
6 = 4ESS
7 = NI-2
0 = Auto
1 = 4 Ports
2 = 8 Ports
3 = 12 Ports
4 = 16 Ports
5 = 20 Ports
6 = 24 Ports
7 = 28 Ports
0 = Disable
1 = Enable
0 = Auto
1 = Manual (Cross)
2 = Manual (Straight)
01~30
n I p t u D a
0~200
0 = D4 (12 Multi Frame)
1 = ESF (24 Multi Frame)
0 = B8ZS
1 = AMI/ZCS
Program 10 : System Configuration Setup
Issue 0.1
D e a f u t l
2
0
0
0
0
0
0
0
0
0
0
a t D e a f u t l
0
0
0