NEC SL1000 Programming Manual page 255

Issue 0.1
Item No. Input Data
01 Received Number
This is the received DID digits.
02 Target Number
Enter the destination number to
which the DID number is sent.
03 DID Name
This is the name that is assigned
to the DID digits when it rings
the extension.
04 Transfer Operation Mode
05 Transfer Destination Number 1 0 =No set
06 Transfer Destination Number 2
400 - Allow the outside party to
dial a different extension number
in the translation table (for
example, ring no answer to a
dialed number, the caller then
hears a dial tone, allowing them
to enter another Valid Extension
Number).401 - Provide the caller
with DISA dialing options
(requires using the DISA
password).
This applies to 22-
11-05 and
22-11-06.
07 Call Waiting
PRG 20-09-07 overrides this
setting.
08 Maximum Number of DID Calls 0~126 (0 =No limit)
09 Music on Hold Source
10 ACI Music Source Port
11 Incoming Ring Group Transfer
Enable (1) or disable (0) each
conversation tables ability to
follow the Ring Group program-
ming defined in Program
22-12-01 : DID Intercept Ring
Group.
If Program 22-11-05 : DID Trans-
lation Number Conversion,
Transfer Destination Number 1
and Program 22-11-06 : DID
Translation Number Conversion,
Transfer Destination Number 2
are set, the priority of transfer-
ring is in this order: Program
22-11-05 then Program 22-11-06
then if Program 22-11-11 is
enabled, Program 22-12-01.
Default
The default value of PRG22-11-01/PRG22-11-02 is shown as below.
Conversion Table
1
Programming Manual
Description
Maximum eight digits
(0-9, , #, @)
*
(0-9, , #)
*
Maximum 36 digits
(0-9, , #, @)
*
Maximum 12 characters
0 = No Transfer
1 = Busy
2 = No Answer
3 = Busy/No Answer
1-25 =Incoming Rin Group
101 = Not used
102 =VMI
103 =Not used
201-232 =Department Group
400 =DUD
401 =DISA
501-599 =DISA
(VRS Message No.)
1000-1999=
Common ABB Dial (000-999)
0 = Disable (No)
1 = Enable (Yes)
0 = IC/MOH Port
1 = BGM Port
2 = ACI Port
When a sound source type is 2 in above : (0~6)
0 = Disable (Caller will hear Ringback)
1 = Enabled (Go to normal ring)
Received number
00
SL1000
Default
See Default Value
See Default Value
No Setting
0
0
0
0
0
0
0
1
Target number
200
2-235
Program
22