Installing Hipath 3550, Hipath 3350, Hipath 3500, And Hipath 3300; Installation Prerequisites - Siemens HiPath 3000 Series Service Documentation

Nur für den internen Gebrauch
4.2

Installing HiPath 3550, HiPath 3350, HiPath 3500, and HiPath 3300

4.2.1

Installation Prerequisites

Warning
7
Only authorized service personnel should install and start up the system.
Tools and resources needed
The following are needed for installing the HiPath 3550, HiPath 3350, HiPath 3500, and HiPath
3300 systems:
Tools:
●
– Diagonal cutting pliers, telephone pliers, wire stripper, flat-nosed pliers
– Slotted screwdrivers, from 2 to 8 mm (1/4 to 5/16 in.)
– Phillips or cross-point screwdrivers, sizes 1 and 2
– TORX screwdriver
– Electric drill, hammer
– Level, tape measure
– For U.S. only: Punch-down tool suitable for the block used (such as block 66)
Resources:
●
– Assistant T or HiPath 3000/5000 Manager E
– Digital multimeter for testing ground connections and partial voltages
– Telephone test set for analog interfaces
– Not for U.S.: ISDN tester (such as K3000 or Aurora)
– For U.S. only: Aurora
er
A31003-H3590-S100-7-7620, 06/2012
HiPath 3000/5000 V9, Service documentation
Installing HiPath 3550, HiPath 3350, HiPath 3500, and HiPath 3300
Duet Expert,
, Aurora
Remote
Aurora or similar, ISDN protocol analyz-
inst_h3.fm
Installing HiPath 3000
4-85