Siemens HiPath 3000 Series Service Documentation page 355

Nur für den internen Gebrauch
Connecting ISDN terminals (not for U.S.)
Depending on the system, you can set up a maximum of four internal S
A maximum of eight ISDN terminals can be addressed on each S
The system does not assign the MSN until the S
MSN can be read out via administration.
When you set up an S
in the system. The S
zure.
If no MSN is entered in the terminal, a default MSN is automatically assigned after
>
you change the S
Configuring an S
0
S telephones cannot be directly connected to an STLS board's Mini-Western jack via the cable
0
supplied. You must first install a jack with cross-connected cables (see Figure 3-69).
Assignment of MW jack pins 1- 8:
8-pin
8 7 6 5
SR SX SX SR
4-pin
4 3
SR SX SX SR
Figure 3-68 Sample Pin Assignments in MW Jacks (not for U.S.)
A31003-H3590-S100-7-7620, 06/2012
HiPath 3000/5000 V9, Service documentation
bus, it is assigned an MSN. This MSN is the first free station number
0
station is immediately available under this MSN, without an outgoing sei-
0
port to "Euro bus" in system administration.
0
bus with a Mini-Western jack (not for U.S.)
4 3 2 1
2 1
port is configured on the "EURO bus"; the
0
6-pin
6 5 4
SR SX SX SR
Mini Western cables are always con-
nected
at the center of the socket!
Boards for HiPath 3000
Peripheral boards
buses (S 1 to S
0 0
bus.
0
3 2 1
boards.fm
4).
0
3-223