Siemens HiPath 3000 Series Service Documentation page 495

Nur für den internen Gebrauch
ANI4 installation instructions
Follow the steps below to install ANI4 in the HiPath 3550 or HiPath 3350 system.
Caution
7
Remove the trunk slip-on connectors from the TMGL4 board before starting to work
on the system.
Be sure to reinstall the ANI4 and TMGL4 boards in their slots before reconnecting
the trunks.
1. Disconnect the trunks from theTMGL4 board (Figure 3-130: Fig. 1).
2. Unplug the system from the power supply.
3. Install the ANI4 board in the system.
4. Connect the OPAL adapter cable to the ANI4 board.
5. Use the ribbon cable supplied to connect ANI4 and TMGL4. The colored marking (pin 1)
on both cable ends must face upwards (Figure 3-130: Fig. 2).
6. Connect the trunk slip-on connectors to the ANI4 (Figure 3-130: Fig. 3).
7. Restart the system by reconnecting the power plug.
Fig. 1
Figure 3-130 ANI4 (for selected countries only) - Installation Steps
A31003-H3590-S100-7-7620, 06/2012
HiPath 3000/5000 V9, Service documentation
Fig. 2
Pin 1
Pin 1
Boards for HiPath 3000
Fig. 3
boards.fm
Options
3-363