Tlani2, Tlani4, Tlani8 - Siemens HiPath 3000 Series Service Documentation

boards.fm
Boards for HiPath 3000
Peripheral boards
3.3.33

TLANI2, TLANI4, TLANI8

NOTE
>
Danger of damage to property due to surge voltage. The required lightning protec-
tion measures must be taken for this board, see Section 2.1.2, "Lightning Protec-
tion".
Introduction
TLANI2, TLANI4 and TLANI8 boards provide 2, 4 and 8 interfaces for the analog trunk connec-
tion (MSI: Ground start or loop start for HiPath 3550 and HiPath 3350 (wall housing) ready.
The interfaces for analog trunk connection support the CLIP feature and call detail recording
with 12 kHz and 16 kHz impulses. Call detail recording is selected automatically via the country
setting of the system. Call detail recording with 50 Hz pulses is not supported.
Not all board country variants support call detail recording with 12 kHz and 16 kHz
>
impulses.
With HiPath 3000/5000 Manager E, call detail recording can be activated and deactivated (Set-
tings menu: Lines/networking ... -> Trunks -> (double-click) Parameters -> MSI flags -> Flags -
> Charge module activated).
"Silent Reversal", which is used to register the beginning and end of an outgoing call in different
countries, is also supported. It can be activated with HiPath 3000/5000 Manager E (Settings
menu: Lines/networking ... -> Trunks -> (double-click) Parameters -> MSI flags -> Flags -> Si-
lent Reversal).
The Austrian direct inward dialing system ÜFS is not supported.
Warning
7
According to U.S. and Canadian installation instructions, analog trunks must be con-
nected over fuse elements in compliance with UL 497A or CSA C22.2 No. 226.
TLANI8 occupation
The TLANI8 can be occupied in the following variants based on a common PCB:
TLANI8-CE (S30810-Q2954-X100): Fully occupied board, i.e. with call charge filter, call
●
detail recording and jumper for ground start/loop start configuration
TLANI8-IM (S30810-Q2954-X101): Board without call charge filter and call detail record-
●
ing, loop start only
TLANI8-BRA (S30810-Q2954-X182): Board without call charge filter
●
3-274
Nur für den internen Gebrauch
A31003-H3590-S100-7-7620, 06/2012
HiPath 3000/5000 V9, Service documentation