Siemens SINAMICS S120 Installation And Start-Up Manual page 62

Commissioning
3.4 Configuring the drive unit using the STARTER commissioning tool
11. Another message is output to inform you that the motors also have to be configured.
Fi gu
12. Initialization is complete. Click Close in the "Automatic configuration" dialog box.
Automatic configu ration is complete
Automatic conf
th t have been found ( a
The following screenshot shows
showing the set and actual topol
that the CBC10 Communication Board i
Figure 3-8
You will now be shown how to configure the motor OFFLINE in STARTER.
3-10
Confirm this message by choosing OK.
re 3-7 Message prompting you to configure the motor
iguration is complete. In the project navigator, all the drive unit components
e.g. Control Unit, CBC10, infeed, and drive) are displayed.
Set and actual topology drive configuration
a configured drive in STARTER. In the work area, the view
ogy has been selected. Among other things, you can see
n the drive line-up has been recognized.
Commissioning Manual, 12.2004 Edition, 6SL3097-2AA00-0BP1
CANopen interface