Limiting The Control Range (Clc_Lim) - Siemens SINUMERIK 840D sl Function Manual

Hide thumbs Also See for SINUMERIK 840D sl:

Table of Contents

Figure 15-11 Response of the CLC offset vector when CLC_GAIN=0.0

Within a part program, a modified gain factor must be reset by means of explicitly programming

CLC_GAIN=1.0.

RESET behavior

CLC_GAIN=1.0 becomes effective after a power on reset, NC RESET or end of program.

Limiting the control range (CLC_LIM)

Lower limit , upper limit

Format and value range as machine data:

● MD62505 $MC_CLC_SENSOR_LOWER_LIMIT[n] (lower clearance control motion limit)

● MD62506 $MC_CLC_SENSOR_UPPER_LIMIT[n] (upper clearance control motion limit)

CLC_LIM(...) is a procedure call and must therefore be programmed in a dedicated part

program block.

Special functions

Function Manual, 01/2015, 6FC5397-2BP40-5BA2

lower limit , upper limit )

TE1: Clearance control - 840D sl only

15.6 Programming

Sinumerik 828d Sinumerik 840de sl