Siemens SINUMERIK 840D sl Function Manual page 804

Z3: NC/PLC interface signals
25.1 F2: 3 to 5-axis transformation
DB21, ...
DBX317.6
Signal state 0 or edge
change 1 → 0
Signal irrelevant for ...
Additional references
DB21, ...
DBX318.2
Edge evaluation: Yes
Signal state 1 or edge
change 0 → 1
Signal state 0 or edge
change 1 → 0
Signal irrelevant for ...
Additional references
DB21, ...
DBX318.3
Edge evaluation: Yes
Signal state 1 or edge
change 0 → 1
Signal state 0 or edge
change 1 → 0
Signal irrelevant for ...
Additional references
804
PTP traversal active
CP traversal active.
No handling transformations active.
Function Manual, Special Functions; 3-Axis to 5-Axis Transformation (F2)
TOFF active
Signal(s) updated:
Activate online tool length offset.
Reset online tool length offset.
The "generic 5-axis transformation" option is not available and no handling transformations
are active.
Function Manual, Special Functions; 3-Axis to 5-Axis Transformation (F2)
TOFF motion active
Signal(s) updated:
Activate offset motion.
Deactivate offset motion.
The "generic 5-axis transformation" option is not available and no handling transformations
are active.
Function Manual, Special Functions; 3-Axis to 5-Axis Transformation (F2)
Function Manual, 01/2015, 6FC5397-2BP40-5BA2
Special functions