Siemens SINUMERIK 840D sl Function Manual page 763

Program code
G1 F10 X=VARIABLE*10-56/86EX4+4*SIN(VARIABLE/3)
ENDFOR
M17
In order to execute this program normally, the following machine data must specify at least 3
names:
MD28020 $MC_MM_NUM_LUD_NAMES_TOTAL
Six names are required to compile this program after POWER ON.
Preprocessed programs/cycles are stored in the dynamic NC memory. The space required for
each program must be flashed over unmodified as outlined above. Adjustment of the memory
mapping in the static NC memory is required only if bit 6 = 1 is set in the following machine
data:
MD10700 $MN_PREPROCESSING_LEVEL (program processing level)
In this case, the program compilations for which there is insufficient space in the dynamic NC
memory are stored in the static NC memory.
Examples for appropriate machine data settings can be found under "Examples" in the
Subsection "Preprocessing in the dynamic NC memory".
Special functions
Function Manual, 01/2015, 6FC5397-2BP40-5BA2
Comment
; 1 name, only for preprocessing
V2: Preprocessing
22.2 Program handling
763