HP 98568A Installation Instruction page 126

HP 98625A Disk Interface
c. Place the card on the envelope.
2. Set the Select Code.
SKIP?
If this is the first (or only) HP 98625 (A or B) Disk Interface
you are installing, you can skip to step 3. The select code is
preset to
14
and need not be changed.
However, if you have the HP 98265A SCSI card, it also is
preset to Select Code 14, so you will need to continue with step
2 to change the select code on your HP 98625A Interface.
a. Find the set of five select code switches by referring to Figure 5-10.
b. Set these switches to one of the four select codes given in Figure 5-11,
unless you have used them elsewhere. Refer to the installation note that
came with the interface if you need additional switch settings.
:~ :~ :~
Select Code 23 Select Code 24 Select Code 26 Select Code 30
Figure 5-11.
3. Set the Interrupt Level.
SKIP?
If you are not using HP-UX, you can skip to step 4. The
interrupt level is preset to 6 and need not be changed. If you
will be using HP-UX continue with step 3.
a. Find the Interrupt Level switches by referring to Figure 5-10.
b. If using HP- UX, set these switches to interrupt level 4 as shown in
Figure 5-10. To get interrupt level 4, set the left switch to 0 and the
right switch to 1. Do not set any other interface to interrupt level
4.
4. Insert the Interface.
5-30 Adding Interface Cards