Installation Procedure - HP 98568A Installation Instruction

HP Series 6300 Model
6501 A
Optical Disk Drive
Installation Procedure
Before you connect your optical disk drive to your computer, refer to the
manual(s) that came with your disk drive to:
• Unpack the disk drive.
• Check that your proposed site for the HP Series 6300 Model 650/ A meets
environmental requirements.
• Check the voltage setting.
• Check the fuse.
And now, the installation procedure ...
1.
Play It Safe.
Turn your computer off, if it is not already off.
2. Set the Address.
a. Locate the SCSI ID and operation mode switch (see Figure 6-1) on the
rear panel of the disk drive.
Figure 6-1.
SCSIID and
Operation Mode Switch
b. Verify that switches 1 through 5 are in the "OFF" position.
c. Switches 6 through 8 are used to set the Address. The Address can be
set from 0 to 6, with 0 being the default setting.
6-10 Adding Mass Storage Devices