Installing Ram Boards In A Model 350 Computer - HP 98568A Installation Instruction

Installing RAM Boards in a Model 350 Computer
This procedure describes how to install HP 98258A/B/C and 98264A/B boards
in your Series 300 Model 350 computer. If you have a Series 200 computer, or
a Series 300 Model 310, 320, or 330, refer to the preceeding sections.
Before turning the computer off, invoke the power-up display (by doing a
Reset).
Copyright 1985.
Hewlett-Packard Company.
All Rights Reserved.
BOOTROM Rev. A2
Bit Mapped Display
MC68020 Processor
MC68881 Coprocessor
Keyboard
HP-IB
HP98620 DMA-CO
HP98644 at 9
HP98625 at 14
HP98643 at 21
XXXXXXX Bytes
Power-up Display
Write down the amount of RAM listed: ________________ Bytes. You will use
this figure later to check that the new RAM board is correctly installed.
Now, shut down the operating system following normal HP-UX procedures
(refer to your System Administrator Manual if you need more information).
Although installing RAM boards in the Model 350 is an easy task, it is broken
down into three short pieces for your convenience:
1. Identifying which RAM boards are already in the computer.
2. Assigning the RAM board addresses.
3. Physically installing the new RAM board in the computer.
3-14 Adding RAM