Installation Procedure - HP 98568A Installation Instruction

HP 7933/7935 Disk Drives
Installation Procedure
Your HP Customer Engineer will unpack and install your disk drive for you.
The following procedure describes how to connect your disk drive to your Series
300 computer.
Caution
Do not attempt to operate the unit until it is moved to the
installation site and the spindle and actuator are unlocked.
Do not apply any sudden mechanical shocks to the unit.
1. Play It Safe.
a. Make arrangements with your HP Customer Engineer to have your disk
drive unpacked and installed.
b. Turn your computer and disk drive off, if they are not already off.
2. Select Your Interface.
Select one of the following interfaces, listed in order of preference for
optimum disk performance:
• HP 98625 Disk Interface
• Built-in HP-IB Interface
3. Set the Address.
a. On the back of the disk drive, find the set of three switches labeled
"HP-IB PRIMARY PORT."
b. Set the HP-IB address:
• If there is only one other disk or tape drive (besides this HP 7933/35)
already connected to the interface, set the "HP-IB PRIMARY PORT"
switches to 2 as shown in Figure 6-9, unless address 2 has been used
elsewhere.
Adding Mass Storage Devices 6-31