HP 98568A Installation Instruction page 220

HP 98726A Interface Card
Worksheet Entries
You have now installed the HP 98726A local Graphics Bus Interface.
The following "Worksheet Entries" contain information needed to use the
Graphics Display Station Interface with the HP-UX operating system.
Copy this information to a worksheet (worksheets are found at the end of
Chapter 1, "Getting Started") or simply remember to refer here when you need
it.
When finished, you'll be ready to install your next peripheral or interface.
Using 010-1
The setting in Table 5-26 is the default setting on the 98726A interface card.
This setting requires the jumper JP1 to be in the $200000 position on the
interface card. This is the recommended choice for the HP 98726A / HP
98730A subsystem used as a console.
Table 5-26.
HP 98730A
Set to Internal Addressing Mode
Switch Setting CTL_BASE
Select Path File
MSB ... LSB (hex) Code Name Type
01010110 $560000
internal /dev/display
c
5-124 Adding Interface Cards
Major Minor
No. No.
12
OxOOOOOO