Installation Procedure - HP 98568A Installation Instruction

HP Series 6100 Model 600/A
CD-ROM Drive
Installation Procedure
Before connecting the CD-ROM drive to your computer, refer to the
instructions that came with the drive to:
• Unpack the CD-ROM drive.
• Check that your proposed site for the Model 600/ A meets environmental
requirements.
• Check the voltage setting.
• Check the fuse.
And now, the installation procedure ...
1. Play It Safe.
a. Bring your system down with the shutdown command.
b. Turn off your computer, monitor, and CD-ROM drive and unplug the
CD-ROM power cord.
2. Select your interface.
You may choose either of these:
• HP 98625 Disk Interface
• Built-in HP-IB Interface
3. Set the address.
Note
You should already be familiar with the HP-IB addresses that
are in use on your system. If you are not, please determine
HP-IB address availability now.
Recognize that multiple disks may exist on the same interface
card; however, no other type of device, for example, tape drive,
may be connected to the same card.
You are limited to four drives per HP-IB card.
• Choose an available HP-IB address.
6-4 Adding Mass Storage Devices