HP 98568A Installation Instruction page 214

HP 98265A Small Computer Systems Interface (SCSI)
• The select code for the SCSI interface card is set by the select code switches
found on the System Interface Board. The default setting (set at the factory)
is 14.
Note
Both the SCSI and the HP 98625A/B interfaces are preset
to select code 14. If you have both SCSI and HP 98625A/B
interfaces, change the select code of the HP 98625A/B Interface
to an unused value.
• The block-mode major number for SCSI interface is 7.
• The character-mode major number for the SCSI interface is
47.
• The minor number for a SCSI interface at select code
14
is OxOeOnOO, where
n is the number that identifies the address of the disk drive.
For instance, suppose you are using an HP 7959S disk drive:
Table 5-25.
Path File Major Minor Interleave
Device Name Name Type Number
Number *
Factor
HP 79598 dev/dsk/OsO
b 7 OxOeOnOO 1
HP 79598 dev/rdsk/OsO
c
47
OxOeOnOO
1
* n is a number that identifies the address. Replace n with a 0 if the address
was set to 0, use 2 if the address was set to 2, and so on.
5-118 Adding Interface Cards