Without A System Bus - HP 98568A Installation Instruction

HP 98248A Floating-Point Accelerator
6. Locate the new, larger System Bus packaged with the Floating-Point
Accelerator and install it onto the Accelerator, processor board and RAM
board(s).
Note
You
must
reinstall the System Bus to ensure system
performance, provide needed air cooling and meet statutory
requirements for fire safety and radiated emissions.
7. Reinstall the power cords and turn the computer and expander on.
Without a System Bus
1. Make sure that the computer and expander are turned off and the power
cords removed.
Caution
In the following steps, handle the circuit boards as little as
possible. Handle them by the edges or backplate only.
2. Locate an empty system slot in the computer, either by moving the video
board to the expander or by removing the cover plate from an empty slot.
3. Remove the Floating-Point Accelerator board set from the packaging
material and slide it into the empty slot. Slide the two-connector end in
first, with the board with the connectors on the bottom.
4. Reinstall the slot cover plate removed in step 2.
Note
You
must
install the slot cover plate to provide needed air
cooling and meet statutory requirements for fire safety and
radiated emissions.
5. Reinstall the power cords and turn the computer and expander on.
4-4 Adding Accessory Cards