HP 98568A Installation Instruction page 55

Step
~~-c
Step 3-d
Step 3-e
Step 4-b
Step 4-c
Step 5-c
(Series 300)
Memory Configuration Wheel
Turn the wheel until the next set of switches comes into view.
Whenever you are told to turn the wheel, always turn the wheel
to the next set of switches.-never use a set of 8witches that is
already in view.
For example, if you come to this step and a set of switches
already appears in the window, you should turn the wheel past
this set of switches and on to the next one. If you come to this
step and an arrow appears in the window or the window is
blank, you should turn the wheel until a set of switches COlnes
into view.
Set the switches on the RAM card to match those shown in
the window.
If you have additional 1 Mbyte RAM cards, begin again at
Step 3-b to set the switches on the next 1 Mbyte RAM carel.
Remember to turn the wheel to the next set of switches when
you repeat Step 3-c.
If you have set the switches on all of your 1 Mbyte RAM cards,
make sure your conlputer is turned off and re-insert all 1
Mbyte RAM cards into your computer. You may insert them
into any slot, but be sure you do not use a slot which was
previously occupied by an interface card (if you have one).
Check that the number of bytes now shown on the screen has
increased over the number you wrote down in Step 2-d.
Turn the wheel clockwise until the nunlber in the Bytes
window approximates the number of bytes you see on the
screen. If the number in the Bytes window is already be set
correctly, you do not have to turn the wheel.
See the advice for Step 3-c. Be sure you turn the wheel
counter clockwise as indicated by the arrows on the edge of the
wheel.
Adding RAM 3-7