Installation Procedure - HP 98568A Installation Instruction

Installation Procedure
HP 2686A/D
La8crJct
HP 33440A La8crJct-IJ
HP 33447A La8crJct-IJD Printer
The following procedure describes how to connect your HP 2686A/D LaserJet,
HP 33440A LaserJet-II, or HP 33447 A LaserJet-IID printer to your Series 300
computer. Before you do this, however, refer to the manual(s) that came with
your printer to:
• Unpack the printer.
• Install the electrophotographic (EP) cartridge.
• Install the fusing roller cleaning pad.
• Install the paper trays.
• Load the paper
• Configure the printer.
And now, the installation procedure ...
Note
Configuration of this interface is not covered in this guide.
Refer to the computer's installation manual to set the baud
rate switches to 9600 baud (switches 1, 2 and 3 to OPEN,
switch 4 to not-OPEN). Set the handshake type switches to
XON/XOFF (switch 1 to not-OPEN, switch 2 to OPEN). The
remaining switches are preset to the correct values for the HP
2686A/D; check them only if you have changed them.
1.
Play It Safe.
Turn your computer and printer off, if they are not already off.
2. Select Your Interface.
Use anyone of the following RS-232C interfaces:
• The built-in RS-232 interface in a Series 300 computer
• HP 98626A RS- 232C Interface
• HP 98628A Datacomm Interface
• HP 98642A 4-Channel Multiplexer Interface
• HP 98644A RS- 232C Serial Interface
Adding Printers 7 -27