Hp 3630A Paintjet Printer - HP 98568A Installation Instruction

HP 3630A PaintJet Printer
Installation Procedure
The following procedure describes how to connect your HP 3630A PaintJet
printer to your Series 300 computer. Before you do this, however, refer to the
manual(s) that came with your printer to:
• Unpack the printer.
• Install the help card.
• Connect the power module.
• Install the print cartridges.
• Load paper
• Run the self test.
And now, the installation procedure ...
1. Play It Safe.
Turn your computer and printer off, if they are not already off.
2. Select Your Interface.
Use either the built-in HP-IB interface or an HP 98624A HP-IB interface. If
possible, avoid placing the PaintJet on the same interface used by your disk
or tape drives.
3. Set the Address.
SKIP?
If this is the first (or only) printer you are connecting to the
interface, you can skip to step 4. The address is preset to 1 and
need not be changed-unless you have changed the address of
some other device on the interface to 1.
a. Find the bank of switches to the left of the HP-IB connector on the rear
panel of the printer. The three right-most switches (labeled A 1 through
A3) in Figure 7-2) determine the address.
b. Set the address to
4
as shown in Figure 7-2, unless address 4 has been
used elsewhere. Refer to the manual that came with the printer if you
need additional switch settings.
Adding Printers 7 -41