Before Starting The Installation; The Expander - HP 98568A Installation Instruction

Before Starting the Installation
The Expander
If your system does not already include an HP 98G70A Backplane Expander,
you lllay need to install and configure one ill order to use this product. If you
already have one, skip down to the next section.
Obviously, if all of the backplane slots in your computer are full, you will need
an expander. If you need to install an expander, do not do so until you have
turned the computer off in order to iIlstall the RAM hardware. Skip the rest of
this section.
If you have a Model
:~GO
computer, you will lleed an expander if either of these
statelllents is true:
• Your video output board consists of two printed-circuit boards
• You have a total of more than four large hoards.
If this condition exists, you will need an expander. If you do not know whether
your video board contains two printed-circuit hoards, check it by loosening the
two screws securing it and sliding it out of the computer (make sure that your
operating systenl is shut down and the computer turned off, first).
Adding RAM 3-3