HP 98568A Installation Instruction page 172

HP 98643A Local Area Network (LAN) Interface
Installation Procedure
LAN installation is not documented here. Refer to the manuals that came with
your LAN system. However, do perform the verification test and fill out your
worksheet after installing the interface. Also record the LAN Interface select
code on the "Select Code Record" form on the Chapter 5, "Interface Cards"
tab.
Note
Both the LAN and SRM interfaces are preset to select code 21.
If you have both LAN and SRM interfaces, change the select
code of the LAN Interface to an unused value.
Verification Test
1. Plug in the power cord and turn your computer on. If you have systems
on-line that the computer can boot, press the space bar a few times to
suspend the automatic booting process.
2. Check the list of components displayed on the left-hand side of the screen:
• If the message,
HP98643,
appears in the list, you have correctly installed
the HP 98643A LAN Interface .
• If the message does not appear, repeat the installation procedure, making
sure there are no select code conflicts and that the card is firmly seated in
an even-numbered slot. If the message still does not appear, call your HP
Service Representative for assistance.
5-76 Adding Interface Cards