ABB IRC5 Product Manual page 142

2 Installation and Commissioning, IRC5
2.9.10. Installation of Hot plug
Continued
Procedure Single Cabinet Controller
The procedure below details how to install the hot plug button in the Single Cabinet
Controller.
140
Action
1.
DANGER!
Before commencing any work inside the
cabinet, please observe the safety
information in section DANGER - Make
sure that the main power has been
switched off! on page 30.
2.
esd
WARNING!
The unit is sensitive to ESD. Before
handling the unit please read the safety
information in the section
unit is sensitive to ESD! on page 31
3. Disconnect the cable from the ethernet
connector for FlexPendant on the
computer unit.
4. Disconnect signal cabling from the panel
board unit.
Note/Illustration
WARNING - The
DSQC639:
xx0600002897
• A: FlexPendant port
xx0600002946
• A: Connector X10
Continues on next page
3HAC021313-001 Revision: P