Probe/Connectors Usage - GE LOGIQ P5 Service Manual

GE H
EALTHCARE
D 5394141, R
IRECTION EVISION
4-3-7

Probe/Connectors Usage

4-3-7-1 Connecting a probe
1.) Place the probe's carrying case on a stable surface and open the case.
2.) Carefully remove the probe and unwrap the probe cable.
3.) DO NOT allow the probe head to hang free. Impact to the probe head could result in irreparable
4.) Turn the connector locking handle counterclockwise.
5.) Align the connector with the probe port and carefully push into place.
6.) Turn the connector locking handle clockwise to secure the probe connector.
7.) Carefully position the probe cable in the probe cord holder spot so it is free to move, but not
4-3-7-2 Activating the probe
Select the appropriate probe from the probe indicators on the monitor screen. The probe selection
screen will be come up when the application key is enabled.
The probe activates in the currently-selected operating mode. The probe's default settings for the mode
and selected exam are used automatically.
4-3-7-3 Deactivating the probe
When deactivating the probe, the probe is automatically placed in standby mode.
1.) Press the Freeze key.
2.) Gently wipe the excess gel from the face of the probe. (refer to the Basic User Manual for
3.) Carefully slide the probe around the right side of the keyboard, toward the probe holder.
4-3-7-4 Disconnecting the probe
Probes can be disconnected at any time. However, the probe should not be selected as the active
probe.
1.) Move the probe locking handle counterclockwise. Pull the probe and connector straight out of
2.) Carefully slide the probe and connector away from the probe port and around the right side of
3.) Be sure that the probe head is clean before placing the probe in its storage box.
4-12
5
damage.
resting on the floor.
complete probe cleaning instructions.)
Ensure that the probe is placed gently in the probe holder.
the probe port.
the keyboard. Ensure the cable is free.
Section 4-3 - General Procedure
LOGIQ™ P5 S M
EVICE ANUAL