Installation Of Decoration Panel - LG MULTI V ARNU07GTUA4 Engineering Product Data Book

Indoor unit
10. Installation

10.4 Installation of Decoration Panel

The decoration panel has its installation
direction.
1. Temporarily fix two decoration panel fixing screws (hexagon M5 screw) on the unit body. (Tighten by amount 10mm in
length.)
The fixing screws (hexagon M5 screw) are included in the indoor unit box.
2. Remove the air inlet grille from the decoration panel. (Remove the hook for the air inlet grille cord.)
3. Hook the decoration panel key hole (
reach the key hole edge.
4. Retighten completely two temporarily fixed screws and other two screws. (Total 4 screws)
5. Connect the louver motor connector and display connector.
6. After tightening these screws, install the air inlet grille
(including the air filter).
Air conditioner unit
Piping side
Louver motor
Decorative panel
Ratch
pull
CAUTION
Install the decoration panel
otherwise cool air leakage
causes condensation.
⇨ Water drops fall.
) on the screws fixed in step above, and slide the panel so that the screws
Push
Inlet Grille
Correct method
Fit the insulator (this part) and
be careful for cool air leakage
Before installing the decoration panel,
always remove the paper template.
Decorative panel
fixing screws
(hexagon M6 screws)
Temporary fitting
at 2 poles
(Tightening about 10mm)
Control box cover
Plasma filter
Key holes
Decorative panel
fixing screws
(Hexagon M6 screw)
Wrong method
Air conditioner
unit
Cool air leakage
(no good)
Ceiling
board
Decoration panel
Ceiling Cassette 2-way
Cover
Air conditioner
unit
Ceiling
board
Decoration panel
_ 19