Table of Contents
Advertisement
DGS-3130 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
VLAN Mapping
This window is used to display and configure the VLAN mapping settings. If a profile is applied on an interface, the
Switch matches the incoming packets according to the rules of the profile. If the packet matches a rule, the action of
the rule will be taken. This action may be adding or replacing the outer-VID, specifying the priority of the new outer-
TAG or specifying the packet's new inner-VID.
The match order depends on the rule's sequence number in the profile and stopped when first matched. If the
sequence number is not specified, it will be allocated automatically. The sequence number begins from 10 and
increments 10. Multiple different types of profiles can be configured on one interface.
To view the following window, click L2 Features > VLAN Tunnel > VLAN Mapping, as shown below:
The fields that can be configured are described below:
Parameter
Unit
From Port - To Port
Port
Original VID List
Original Inner VID
Action
VID
Inner VID
Priority
Click the Apply button to accept the changes made.
Click the Find button to locate a specific entry based on the information entered.
Click the Delete button to delete the specified entry.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
Figure 5-40 VLAN Mapping Settings Window
Description
Select the Switch unit ID that will be used here.
Select the port range that will be used here.
Select the port that will be used for the search here.
Enter the original VLAN ID list here. The range is from 1 to 4094.
Enter the original inner VLAN ID here. The range is from 1 to 4094.
Select the action that will be taken here. Options to choose from are Translate
and Dot1q-tunnel.
• Translate - Specifies that the outer-VID will replace the outer-VID of the
matched packets.
• Dot1q-tunnel - Specifies that the outer-VID will be added for matched
packets.
Enter the VLAN ID here. The range is from 1 to 4094.
Enter the inner VLAN ID here. The range is from 1 to 4094.
Select the 802.1p priority value here. The range is from 0 to 7. A higher value
has a higher priority.
126
Advertisement
Table of Contents
