Jumbo Frame - D-Link DGS-3130 Series Web Ui Reference Manual

DGS-3130 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
The fields that can be configured for Error Disable Trap Settings are described below:
Parameter
Asserted
Cleared
Notification Rate
Click the Apply button to accept the changes made.
The fields that can be configured for Error Disable Recovery Settings are described below:
Parameter
ErrDisable Cause
State
Interval
Click the Apply button to accept the changes made.

Jumbo Frame

This window is used to display and configure the jumbo frame size and settings. The Switch supports jumbo frames.
Jumbo frames are Ethernet frames with more than 1,518 bytes of payload. The Switch supports jumbo frames with a
maximum frame size of up to 9,216 bytes.
To view the following window, click System > Port Configuration > Jumbo Frame, as shown below:
Description
Specifies to enable or disable notifications for entering into the error disabled
state.
Specifies to enable or disable notifications for exiting from the error disabled
state.
Enter the notification rate value here. This sets the number of traps per minute.
The packets that exceed the rate will be dropped. The range is from 0 to 1000.
The default value (0) indicates that an SNMP trap will be generated for every
change of the error disabled state.
Description
Select the error disabled cause here. Options to choose from are Port
Security, Storm Control, BPDU Attack Protection, Dynamic ARP
Inspection, DHCP Snooping, Loopback Detect, L2PT Guard, and D-Link
Unidirectional Link Detection.
Select to enable or disable the error disabled recovery feature here.
Enter the time, in seconds, to recover the port from the error state caused by
the specified module. The range is from 5 to 86400.
13