Vrrp Settings - D-Link DGS-3130 Series Web Ui Reference Manual

Hide thumbs Also See for DGS-3130 Series:
Table of Contents

Advertisement

DGS-3130 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
The fields that can be configured are described below:
Parameter
Route Map
Click the Apply button to accept the changes made.

VRRP Settings

This window is used to display and configure the Virtual Router Redundancy Protocol (VRRP) settings. All routers in
the same VRRP group must be configured with the same virtual router ID and IP address.
A virtual router group is represented by a virtual router ID. The IP address of the virtual router is the default router
configured on hosts. The virtual router's IP address can be a real address configured on the routers, or an unused IP
address. If the virtual router address is a real IP address, the router that has this IP address is the IP address owner.
A master will be elected in a group of routers that supports the same virtual routers. Others are the backup routers.
The master is responsible for forwarding the packets that are sent to the virtual router.
To view the following window, click L3 Features > VRRP Settings, as shown below:
The fields that can be configured in VRRP Settings are described below:
Parameter
SNMP Server Traps VRRP
New master
SNMP Server Traps VRRP
Auth Fail
Non-owner-ping Response
Description
Enter the route map name here that will be used in this policy route entry.
Figure 6-89 VRRP Settings Window
Description
Select to enable or disable the SNMP server traps feature for the new VRRP
master. If enabled, once the device has transitioned to the master state, a trap
will be sent out.
Select to enable or disable the SNMP server traps feature for authentication
failures. If enabled, if a packet has been received from a router whose
authentication key or authentication type conflicts with this router's
authentication key or authentication type, then a trap will be sent out.
Select to enable or disable the non-owner ping response feature here. This
feature is used to enable the virtual router in the master state to respond to
ICMP echo requests for an IP address not owned but associated with this
virtual router.
243

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dgs-3130-30ts

Table of Contents