Table of Contents
Advertisement
DGS-3130 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
DDM
This folder contains windows that perform Digital Diagnostic Monitoring (DDM) functions on the Switch. There are
windows that allow the user to view the digital diagnostic monitoring status of SFP/SFP+ modules inserting to the
Switch and to configure alarm settings, warning settings, temperature threshold settings, voltage threshold settings,
bias current threshold settings, Tx power threshold settings, and Rx power threshold settings.
DDM Settings
The window is used to view and configure the action that will occur for specific ports when an exceeding alarm
threshold or warning threshold event is encountered.
To view the following window, click OAM > DDM > DDM Settings, as shown below:
The fields that can be configured in DDM Global Settings are described below:
Parameter
Transceiver Monitoring
Traps Alarm
Transceiver Monitoring
Traps Warning
Click the Apply button to accept the changes made.
The fields that can be configured in DDM Shutdown Settings are described below:
Parameter
Unit
From Port - To Port
State
Shutdown
Figure 10-27 DDM Settings Window
Description
Select to enable or disable the transceiver monitoring traps alarm feature here.
Select to enable or disable the transceiver monitoring traps warning feature
here.
Description
Select the Switch unit that will be used for this configuration here.
Select the appropriate port range used for the configuration here.
Use the drop-down menu to enable or disable the DDM state.
Specify whether to shut down the port, when the operating parameter exceeds
the Alarm or Warning threshold.
• Alarm - Shutdown the port when the configured alarm threshold range is
exceeded.
399
Advertisement
Table of Contents
