Table of Contents
Advertisement
DGS-3130 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
Click the Find button to locate a specific entry based on the information entered.
Click the Show All button to display all the entries.
RIPng
RIPng Settings
This window is used to display and configure the Routing Information Protocol Next Generation (RIPng) settings, also
known as IPv6 RIP.
To view the following window, click L3 Features > RIPng > RIPng Settings, as shown below:
The fields that can be configured in RIPng Global Settings are described below:
Parameter
Global State
Click the Apply button to accept the changes made.
The fields that can be configured in RIPng Settings are described below:
Parameter
Default Metric
Distance
Update Time
Figure 6-202 RIPng Settings Window
Description
Select to globally enable or disable the RIPng feature here.
Description
Enter the default metric value here. The range is from 1 to 16. This value is
used to specify the default metric for routes redistributed from other routing
protocols. If the routes being redistributed are learned from other protocols,
then they have an incompatible metric with IPv6 RIP. Re-specifying of metric
allows the metric to be synced.
Select the Default option to use the default metric value, which is 0.
Enter the administrative distance for RIPng here. The range is from 1 to 254.
The distance value represents the trust rating of the route. The route with a
lower distance value is preferred over the route with the higher distance value.
Select the Default option to use the default administrative distance for RIPng,
which is 120.
Enter the update interval value at which the update message is sent here. The
range is from 5 to 65535 seconds.
204
Advertisement
Table of Contents
