Radius Server Settings - D-Link DGS-3130 Series Web Ui Reference Manual

DGS-3130 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
Parameter
Click the Apply button to accept the changes made.
The fields that can be configured in RADIUS Global IPv4 Source Interface are described below:
Parameter
IPv4 RADIUS Source
Interface Name
Click the Apply button to accept the changes made.
The fields that can be configured in RADIUS Global IPv6 Source Interface are described below:
Parameter
IPv6 RADIUS Source
Interface Name
Click the Apply button to accept the changes made.
The fields that can be configured in RADIUS Server Attribute Settings are described below:
Parameter
RADIUS Server Attribute
NAS-IP-Address
Click the Apply button to accept the changes made.

RADIUS Server Settings

This window is used to display and configure the RADIUS server settings.
To view the following window, click Security > RADIUS > RADIUS Server Settings, as shown below:
Description
improve the authentication processing time by setting the dead time to skip the
unresponsive server host entries.
When the system performs authentication with the authentication server, it
attempts one server at a time. If the attempted server does not respond, the
system will attempt the next server. When the system finds a server does not
respond, it will mark the server as down, start a dead time timer, and skip them
in authentication of the following requests until expiration of the dead time.
Description
Enter the name of the IPv4 RADIUS source interface here.
Description
Enter the name of the IPv6 RADIUS source interface here.
Description
Enter the RADIUS server's attribute NAS-IP-Address here
Figure 9-30 RADIUS Server Settings Window
319
.