Poe Status - D-Link DGS-3130 Series Web Ui Reference Manual

DGS-3130 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
Parameter
Usage Threshold
Policy Preempt
Trap State
Click the Apply button to accept the changes made.
Click the Show Detail button to see the PoE system Parameters table at the bottom of the window.
After clicking the Show Detail button, the following window will appear.

PoE Status

This window is used to configure the description and display the PoE status of each port.
To view the following window, click System > PoE > PoE Status, as shown below:
Description
Enter the usage threshold to generate a log and send the corresponding
standard notification. The range is from 1 to 99 percent.
Select this option to enable or disable the disconnection of the Powered Device
(PD) which is power-provisioned with a lower priority in order to release the
power to the new connected PD with higher priority under power shortage
conditions.
Select this option to enable or disable the sending of PoE trap notifications.
Figure 3-112 PoE System (Show Detail) Window
16