Table of Contents
Advertisement
DGS-3130 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
The fields that can be configured are described below:
Parameter
Unit
From Port - To Port
MAC/PHY
Configuration/Status
Link Aggregation
Maximum Frame Size
Energy-Efficient Ethernet
Click the Apply button to accept the changes made.
LLDP-MED Port Settings
The LLDP-MED Port Settings page is used to enable or disable outbound LLDP advertisements for LLDP-MED TLVs.
To view the following window, click L2 Features > LLDP > LLDP-MED Port Settings, as shown below:
Figure 5-789 LLDP Dot3 TLVs Settings Window
Description
Select the Switch unit that will be used for this configuration here.
Select the appropriate port range used for the configuration here.
Select this option to enable or disable the MAC/PHY Configuration/Status TLV
to send. The MAC/PHY Configuration/Status TLV is an optional TLV that
identifies (1) the duplex and bit-rate capability of the sending IEEE 802.3 LAN
node, and (2) the current duplex and bit-rate settings of the sending IEEE 802.3
LAN node.
Select this option to enable or disable the Link Aggregation TLV to send. The
Link Aggregation TLV indicates contains the following information. Whether the
link is capable of being aggregated, whether the link is currently in an
aggregation, and the aggregated port channel ID of the port. If the port is not
aggregated, then the ID is 0.
Select this option to enable or disable the Maximum Frame Size TLV to send.
The Maximum Frame Size TLV indicates the maximum frame size capability of
the implemented MAC and PHY.
Select this option to enable or disable the Energy Efficient Ethernet TLV to
send. The Energy Efficient Ethernet TLV indicates the reduce energy
consumption capability of a link when no packets are being sent.
178
Advertisement
Table of Contents
